KISSFC Firmware Update (v1.02beta74)

Please only use it if you like to try out new things, knowing there might be some parts unstable!

Go to German Version

Changes from 1.01 to 1.02 beta7:

FrSky Smartport telemetry support (see instructions below)
Gr. HOTT telemetry support (see instructions below)
Futaba SBus2 should now work with Futaba SBus selected untested!
Jeti telemetry workes now with Jeti Ex-bus
There are now new advanced configurations added (see manual below)
Added two new channel orders for PPM (PPM:Pitch,Roll,Thr.,Yaw and PPM:Roll,Pitch,Thr.,Yaw)
Improved Gyro calibration. The Gyro should calibrate faster and more reliable.

Changes from 1.02 beta5 to 1.02 beta7:

FrSky Smartport telemetry support improved. now the telemetrie refresh rate is insane
Gr. HOTT telemetry support (see instructions below)
Futaba SBus2 second try. now it really should work! (it measures the time between the received pakages to detect the start)untested!
Added two new channel orders for PPM (PPM:Pitch,Roll,Thr.,Yaw and PPM:Roll,Pitch,Thr.,Yaw)
Improved Gyro calibration. the Gyro should calibrate faster and more reliable.

Update Instructions

Step 1:

Download the KISSFC update file v1.02 beta 74

KISSFC v1.02 beta 74 update Download

Step 2:

Follow the instructions of the update from v1.01 but using the file downloaded above.

General Update instructions

FrSky Smartport telemetry support

1. connect your RX

2. add sensors in the Taranis menu

power the FC and RX (Smartport telemetry is only active as long as FrSky SBus is selected as RX type), go to menu and then press page till you come to telemetry menu. there select "Discover new sensors". you should get beside some others the new sensors:

VFAS (the lipo voltage in V)
Current (the total current A)
Fuel (the used mAh's)

* note Current and Fuel will stay zero if you dont have supported telemetry ESC's connected (KISS24A for example)

Gr. HOTT telemetry support

1. connect your RX

2. Setup your MX-xx

power the FC and RX (HOTT telemetry is only active as long as SUMD is selected as RX type), go to menu -> telemetry -> RX setup and enable sumd and the sensor pin

* note1 to let the TX find the sensor, you should power the FC and RX close after turning on your TX. as the TX just searches for some time after it is turned on.
* note2 Current (A) and the consumption (mAh) will stay zero if you dont have supported telemetry ESC's connected (KISS24A for example)

new advanced Configuration

If you connect a KISS FC with version 1.02x on it you will get a small extra button that can be seen, when enlarging the GUI window in confuguration tab

you can setup TPA influence and battery influence:

TPA influence

here you can configure the influence of the TPA values in relation to the throttle.

Battery influence

its ment to decouple the PID values from the lipos voltage. (normaly PID's feel stronger with higher voltage)